Revision as of 03:56, 27 June 2011 by Andre (Talk | contribs)
Jump to: navigation, search

Proceed® Full-Bodied Painting & Glazing Medium and Low Viscosity Painting & Glazing Medium are designed for easy blending and exceptionally long working time. You can use them for traditional and contemporary glazing techniques. You can also use either glaze to thin out thicker products or increase workability, rollability and open time. Both Glazes have a thixotropic characteristic meaning they thicken at rest. This means you'll see separation in the container if the product has been sitting for an extended amount of time. This is normal. Simply shake and the two "phases" will mix back into themselves.

These glazes have a lot of open time, adjusting the sheen and absorbency of the paint beneath it will increase your control within different environmental conditions. For example, working in humid South Carolina in July may cause you to basepaint with a Satin or Eggshell sheen instead of the Semi-Gloss that was used the previous winter to have the same open time.

  • Please review the Painting & Glazing Mediums Application Guide
  • Here is an instructive presentation on the differences between the two glazes and aspects of the Slow Drying Fluid Acrylics compared to other known types of paint, created by our European distributors, Obeeliks, can be viewed here: File:Proceed.ppt

Tinting Glazes

Mix with Slow-Drying Fluid Acrylics at any desired ratio or with Pigment Dispersions up to a 5:1 ratio of Glaze to Dispersion. Do not mix with oil paint. Glossy, non-absorbent surfaces should be abraded for increased adhesion. Full cure requires 24-48 hours. Seal with a varnish/topcoat for maximum durability. Clean tools with soap and water.


This category has the following 2 subcategories, out of 2 total.



Personal tools